Teaching-In - HomeMatic basic Anleitung

If both tube ends should maintain opened, you do not need to
open the hose clamp. You can simply put the hose clamps over
the tubes and connect them using the tube connector profiles.
• Fasten the hose clamp using an appropriate screwdriver (see fig. 3).
6

Teaching-in

Please read this entire section before starting the teach-in pro-
cedure.
First set up your Homematic IP Access Point via the Homematic
IP app to enable operation of other Homematic IP devices within
your system. For further information, please refer to the operat-
ing manual of the Access Point.
You can connect the device either to the Access Point or to the
Homematic Central Control Unit CCU2. For detailed information,
please refer to the Homematic IP User Guide, available for down-
load in the download area of www.eQ-3.com.
To teach-in the weather sensor to the Access Point, please proceed as
follows:
• Open the Homematic IP app on your smartphone.
• Select the menu item "Teach-in device".
Loosen the cover of the main sensor (B) by turning the cylinder
•
clockwise and pulling it downwards.
• Remove the insulation strip from the battery compartment (E) to
Teaching-in
27