Kärcher BD 530 Ep Classic Originalbetriebsanleitung Seite 24

Cleaning
 Tilt the chassis upward and lock it.
 BD 530 Bp: Switch on the button for
brush operations and suction turbine
 BD 530 Ep: Insert the plug into the
socket.
Turn the main switch to position "1" and
switch the suction turbine on.
 Press control switch.
Note
If the brush motor does not run when
switched on, then brush motor is to be re-
leased by pulling the machine backward.
 Perform the cleaning operation.
Setting the advance speed
 Reducing the speed: Turn the button in
"–" direction.
 Increasing the speed: Turn the button in
"+" direction.
Setting the water quantity
 Set the water quantity at the regulation
knob according to the dirt level and the
type of flooring.
24
Note
Carry out initial cleaning attempts with low
quantity of water. Slowly increase the wa-
ter quantity till the desired cleaning result is
achieved.
Setting the Vacuum Bar
Oblique position
To improve the vacuuming result on tiled
floors the vacuum bar can be turned to an
oblique position of up to 5°.
 Loosen cross-handles.
 Turn the vacuum bar.
 Tighten the cross-handles.
Inclination
If the vacuum result is unsatisfactory the in-
clination of the straight vacuum bar can be
modified.
 Release the wing nuts.
 Tilt the vacuum bar.
 Tighten the wing nuts.
– 7
EN