IKEA RULLBO Bedienungsanleitung Seite 6

ENGLISH
Safety information
For your safety and correct
operation of the appliance, read
this manual carefully before
installation and use. Look carefully
at the warning pictures at the
beginning of this manual. For a
correct and complete installation,
refer to the specific installation
manual provided with the product.
Always keep these instructions with
the appliance even if you move or
sell it. Users must fully know the
operation and safety features of
the appliance.
The wire connection has to be done
by specialized technician.
• The manufacturer will not be held
liable for any damages resulting
from incorrect or improper
installation.
• The minimum safety distance
between the cooker top and the
extractor hood is: for electrical hob
500mm and for gas hob 650mm.
• If the instructions for installation
for the gas hob specify a greater
distance, this must be respected.
• Check that the mains voltage
corresponds to that indicated on
the rating plate fixed to the inside
of the hood.
• Means for disconnection must be
incorporated in the fixed wiring in
accordance with the wiring rules.
• For Class I appliances, check
that the domestic power supply
guarantees adequate earthing.
• Connect the extractor to the
exhaust flue through a pipe of
minimum diameter 150mm. The
route of the flue must be as short as
possible.
To download the full version visit www.ikea.com
• Do not connect the extractor
hood to exhaust ducts carrying
combustion fumes (boilers,
fireplaces, etc.).
• If the extractor is used in
conjunction with non-electrical
appliances (e.g. gas burning
appliances), a sufficient degree of
aeration must be guaranteed in
the room in order to prevent the
backflow of exhaust gas. When the
cooker hood is used in conjunction
with appliances supplied with
energy other than electric, the
negative pressure in the room must
not exceed 0.04 mbar to prevent
fumes being drawn back into the
room by the cooker hood.
• The air must not be discharged into
a flue that is used for exhausting
fumes from appliances burning gas
or other fuels.
• If the supply cord is damaged,
it must be replaced from the
manufacturer or its service agent.
• Connect the plug to a socket
complying with current regulations,
located in an accessible place.
• With regards to the technical and
safety measures to be adopted for
fume discharging it is important
to closely follow the regulations
provided by the local authorities.
WARNING:
the Hood, remove the protective
films.
• Use only screws and small parts in
support of the hood.
WARNING:
the screws or fixing device in
accordance with these instructions
may result in electrical hazards.
Before installing
Failure to install
6