Singer ESP2 Bedienungsanleitung Seite 8

Shirts and Blouses
1. Place the shoulder yoke on the Ironing Board first and press.
2. Then place the sleeves on the Ironing Board with the fold parallel to the long seam and
press.
3. Place the cuffs on the end of the board and
press.
4. Place the bottom of the shirt ironing board so
that you begin pressing pressing the side with
the pocket. Pull the shirt towards you as you
Press each section.
5. Then finish with the collar of shirt.
Pants
1. Place the Pressing Cushion under the waistband and press, repositioning the
waistband until completely pressed.
2. To press the in-seam, place the cushion under the area to be pressed.
3. Place the pleated area on the Ironing Board. Carefully fold pleats and press.
4. Embroidery should be placed face down on the Ironing Board to reduce wear and
prevent damage to delicate areas.
Other Techniques
1. Placing the pressing cushion between the fabric and the Pressing Plate may help with
delicate fabrics.
2. Buttons and Zippers: if you have older types of buttons or zippers, you may need to
take special care to avoid melting. In order to do so, place the garment face down and
cover with a pressing cushion before pressing.
3. Spray bottle may be used to spray the fabric lightly. This will further help to remove
stubborn wrinkles.
6
struction Manual.indd 6 23.12.2011 15:25