Singer ESP2 Bedienungsanleitung Seite 7

OPERATION INSTRUCTIONS
1. Turn the ON/OFF Switch to the"on"position.
2. Identify the type of fabric you will press and then select the temperature setting that
matches the fabric to be pressed. It is best to start with the most delicate fabrics first,
as higher heat will cause damage to Nylon and Silks.
3. Lay fabric flat on Ironing Board.
4. Digital Fabric Steam Press is ready for use when Pressing Indicator Light deactivates.
If pressing wool, you may choose to spray with a burst of steam. This function is
available once Steam Burst Ready Indicator Light illuminates.
NOTE: Do not activate burst of steam with unit completely closed, as this may damage
unit. Best results are obtained if Pressing Plate is held open approximately 75 mm above
Ironing Board before pressing Steam Button. For safety reasons, do not hold Pressing
Plate open more than 75 mm when using steam burst function.
5. To press, lower Pressing Plate gently onto fabric and Ironing Board. Hold there for 6-8
seconds, then lift up Pressing Plate. Repeat until you have achieved desired crease
and smoothness.
6. Once Pressing tasks are complete, immediately set On/Off Switch to "off"position.
TIPS PRESSING
STEAM BURST
1. Hold Pressing Plate approximately 3"
above Ironing Board.
2. Press Steam Burst Button to release a
burst of steam onto fabric.
3. Lower Pressing Plate onto fabric, then
raise once again.
4. Repeat steps 1-3 above until fabric is
smooth and wrinkle-free.
IMPORTANT NOTE
FOR BEST RESULTS, PRESS BUTTON FOR
2 SECONDS AND RELEASE.
STEAMING TIPS
Pressing Garments
1. Lay the garment on the Ironing Board.
2. Lower the steam plate and return to the
open position after a few seconds.
NOTE: the unit will automatically turn off the
heating plate after 10 seconds in the closed
position. A beep will emit until the unit is
opened. Once the unit is opened, it will return
to normal operation.
Wrinkle Removal
1. Lower the Steam Plate until it is slightly above the Ironing Board(about three inches).
2. Activate the Burst of Steam with the buttons on the sides of the Pressing Handle.
3. Wait a few seconds, and activate the Burst of Steam again.
4. Lower the Pressing Plate and then raise.
5. Repeat this process until all wrinkles have been removed.
struction Manual.indd 5
5
23.12.2011 15:25