Haier HW80-BD1626 Gebrauchanleitung Seite 5

Control panel -
function buttons
To get best results in each programme Haier has well defined specific default settings.
If there is no special requirement default settings are recommended. Accordingly to
these factory settings many programme parameters and additional functions could be
individually changed (see "programmes" and "function" buttons).
"Function" (button a)
Touch it to select sequentially required functions and set-
1 2 3
tings. The related symbol will shine.
1 2 3
"Selection" (button b)
Touch it to confirm the current chosen „Function", its
Wasch-
Function Selection
mittel
symbol is blinking. Additionally a "checkmark", a "1"/"2"/"3"
symbol, or one of the stain symbols will light up. Function
will be activated after 3 seconds or if button a ("Function")
is touched.
a b
"Child lock" - control panel lock function
(button a + b)
This option blocks all panel elements against activation. Press
simultaneously "Function"+"Selection" for about 3 seconds.
Panel lock symbol is now displayed. Next repetition deblocks
any function.
"Detergent" (button c)
Touch it to deactivate or activate "Smart Dosing" for liquid
detergent. If default setting liquid detergent (see "Smart
Dosing") is deactivated detergent drawer compartment 2 is
to be used for all kinds of washing agent.
Detergent Softener
"Softener" (button d)
Touch it to deactivate, or activate an additional dosage of
softener (see "Smart Dosing").
c d
"Smart Dosing " (button c or button d)
"Smart Dosing" is default setting. Means, due to programme,
laundry load and water hardness there will be an optimal au-
tomatic dosage of liquid detergent and softener using related
compartments 1 (1,3l) and 3 (0,5l) of the detergent drawer.
If activated according symbols will light up.This function
achieves optimal results, saves washing agent and protect our
environment. A charge lasts for up to 20 programme cycles.
If a reservoir is empty related symbol will be blinking.
8 9
"Delay" - End time delay (button e)
Touch it to light up related symbol and display present
programme end time. Accordingly to all programme settings
start of wash cycle will be delayed.
End time delay could be increased by turning programme
selector in steps of 30 minutes from 0,5-24h. For example,
display of "6:30" means end of programme cycle will be in 6
hours and 30 minutes.
It is not applicable to programme "Spin/Drain".
Note: End time must always be longer than programme
cycle time. Otherwise operation will start immediately,
although chosen end time could not be reached.
"Temperature" (button f)
Touch it to adapt maximum of water temperature.
Note: Display of "--" stands for
"Spin" (button g)
Touch it to adapt speed of centrifugation.
"Memo" (button h)
Memory function is available in programme "Cotton" (M1),
"Synthetic" (M2), "Mix" (M3). After selecting individual
options and related values touch "Memo" button until
display shows related "M1"/"M2"/"M3". Start programme,
memory is now activated for chosen programme. When that
programme will be chosen next, press "Memo" button to
activate memorized setting and be at once ready to start.
General information and tips:
To cancel any actual setting change programme or press
"On/Off " about 3 seconds. To cancel a running program-
me touch "Start/Pause" and then "On/Off " for about 3
seconds.
Control panel
function buttons -
Time display
(related to current
operation)
e f g h
"
no operational heating".
M
rpm