In Case Of Power Failure - Haier HW80-BD1626 Gebrauchanleitung

Troubleshooting
Display code
Code Cause
Auto Automatic load detection.
1:25 Remaining wash cycle time.
19:30 Remaining wash cycle time.
Lock Automatic door locking.
End End of wash cycle.
E1 Drainage error, water not emptied.
E2 Lock - error.
F3 Temperature sensor - error.
E4 Water level not reached after 8 minutes.
F4 Heating error (Appears at the end of a cycle). Contact the After sales service.
F7 Motor - error.
E8 Water protective level - error.
Fb Water overflow.
FA Water level sensor error.
FC Electronic control - error.
Unb Unbalanced load - error.
Warning!
Code Fb: Water-overflow protection is placed on deepest part of appliance. In case of leacka-
ge all functions will be shut down automatically except drain pump which will be activated for
safety reasons.
20
Solution
Wait until programme cycle time
is displayed
Refer to additional symbol.
End is likely delayed - refer to symbol.
Wait until operation ends and
code disappear.
Clean pump filter.
Check drain hose for blockage
and proper installation.
Shut the door properly.
Contact the After sales service.
Check if water supply
and water pressure is normal.
Drain hose is self-syphoning.
Contact the After sales service.
Contact the After sales service.
Close tap immediately.
Contact the After sales service.
Contact the After sales service.
Contact the After sales service.
Cut power supply. Check and
balance laundry load. Try to run a
spinning programme.
21

In case of power failure

The current programme and its setting will be saved only
for a short time. Probably a new programme cycle start is
needed.
If a power failure cuts an operating wash programme door
opening is mechanically blocked. To get out any laundry
water level should not be seen in the glassy porthole of the
door - danger of burns!
Water level has to be lowered as described in "Pump filter".
Not till then pull lever beneath service flap until door is
unlocked by a gentle click. Afterwards refix all parts.
Troubleshooting without display code
Problem Cause Solution
Washing machine Programme is not yet started.
fails to operate. Door is not properly closed.
Machine has not been switched on. Switch the machine on.
Power failure.
Washing machine No chosen programme.
will not be filled No water.
with water. Inlet hose is kniked.
Inlet hose filter is blocked.
Water pressure is less than
0,03 MPa.
Water supply failure.
Machine is draining Height of drain hose is
while being filled below 80 cm.
Drain hose end could
reach into water.
Troubleshooting
lever
Press "Start/Pause" button.
Close the door properly.
Check power supply.
Set programme and start it.
Check water tap.
Check inlet hose.
Unblock inlet hose filter.
Check water pressure.
Ensure the water supply.
Make sure that drain hose
is properly installed.