Using Boost Mode; Using Illumination; Using The Aux Input - Panasonic SCRB5E Bedienungsanleitung

Using Boost Mode

It will make the sound played back on this unit easier to hear by boosting the level of specific
frequency band.
Touch [BOOST] of this unit to switch the effect on/off.
• The default setting is on.
• When the Boost Mode is on, the indicator (blue) lights up.
Note
• If sound is distorted during playback, switch off the "Boost Mode".
• When saving the power consumption, set "Boost Mode" to "off".
• Location of this unit may move due to vibration.

Using illumination

The sound illumination bars light in a way synchronized with the loudness of your audio content.
• The sound illumination bars do not produce much light at low volume levels.
Touch and hold [BOOST] for at least 2 seconds to switch the effect on/off.
• The default setting is on.

Using the AUX input

You can listen to audio via the AUX IN terminal (
an audio cable (not supplied).
Note
• Depending on the track or the volume, the flashing pattern of the illumination bars differs.
• When using the AUX input, AUX input has priority than the Bluetooth
• The setting of the Bluetooth
into AUX IN terminal.
• When using the AUX input, the volume may seem low depending on the connected device. In
that case, check if the volume limit can be changed on the device. For details, refer to the
manual of the device.
• If an audio cable is inserted during audio playback with a Bluetooth
occur. In this case, stop the playback on the device connected via Bluetooth
®
• When a Bluetooth
terminal immediately after inserting it, no sound may be output. If this occurs, reinsert the
cable all the way in, and then disconnect it.
®
is not changed even if the audio cable (not supplied) is inserted
connection is active, if you disconnect the audio cable from the AUX IN
6) when this unit is connected to a device with
®
®
features.
connection, noise may
®
.
9
9