HOMCOM YH-20-3 Montageanleitung Seite 3

• The product cannot be used outdoors.
• Do not block the fireplace vent in anyway – it could overheat, causing a fire hazard.
• If there any faults or damages, unplug this unit immediately.
• If the unit has not been used for a while, ensure the power is off.
• Do not place the power cord in front of the fireplace.
• It is NOT recommended to use this unit on any type of carpet or rug.
• Dispose of packaging properly and carefully. Plastic materials can cause environmental
pollution.
• The product must be connected to the ground.
• The fireplace must be used under the AC voltage rating.
• This product is fitted with a thermostatic room temperature control.
Only for UK:
A.Do not use two high-power appliances in the same socket.
B.The plug needs to be plugged in fully.
C.Product socket cannot use extension cord.
The socket needs to be conformed to BS1363, the maximum withstand current value needs
to be greater than 13A.
Location of Controls
1. Thermostat control knob ( TEMPERATURE SETT I NG)- Adjust to ma i ntain room temperature.
2. Flame switch - Switches flame effect and power on/off.
3. Heating sett i ng: please press "
4. Heating sett i ng : p l ease press "
first press " ")
5. F l ame dimmer control - Adjust to set flame intens i ty.
" for 750W.
" and " " at the same t i me for 1500W (can not operate w i thout
3
WARNING: Do not use th i s heater with
m i ssing, damaged, or broken legs.