HOMCOM 820-007 Montageanleitung Seite 6

Instructions for Use
The appliance can be operated either by the switches located on the top right hand side
of the fire or by the supplied remote control.
Temperature and serial number display: Normally it displays the room
temperature; while setting the temperature, the setting temperature is displayed;
When setting the timer, serial number is displayed.
Time/ Temperature display: Normally it displays the current time; while setting the
timer, the setting time is displayed. When setting the temperature of the week timer,
the setting temperature is displayed.
Time on and time off: It is displayed while setting the timer, and it is used in
combination with serial number setting.
Flame brightness: It displays the current brightness of the flame, which ranges from
one to five positions.
Manual Operation
This is done by operating the switches located at the top right hand side of the fire. The
standby rocker switch must first be switched on, the fire will beep to indicate that it is
powered up.
Press the O/I button once to turn on the appliance and fire effect. A red indicator light will
show to indicate that the fire is ON. Press the O/I button for 3 seconds this will operate
the dimmer mode, hold the button down until the desired brightness is obtained.
820-007: Press the 1000W button once for the low heat setting; press twice to switch off
the heat setting. Press the 2000W button once for the high heat setting; press twice to
switch off the heat setting.
820-054: Press the 900W button once for the low heat setting; press twice to switch off
the heat setting. Press the 1800W button once for the high heat setting; press twice to
switch off the heat setting.
6