Herunterladen Inhalt Inhalt Diese Seite drucken

Preparation Of The Illuminant; Installation - EuroLite DMX SUPER SROBE 2700 Bedienungsanleitung

Dmx stroboskop mit 1500 watt
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

PREPARATION OF THE ILLUMINANT

To prevent damage, the flash tube is protected by packaging material for transport. All packaging material
has to be removed before taking the device into operation.
1
Unscrew the screws (1) of the protective shield.
2
Remove the protective screen.
3
Remove all packaging material from the flash-tube.
4
Replace the protective screen and tighten the screws.

INSTALLATION

WARNING! Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure
that the device is installed securely and cannot fall down. The installation must be carried out by
a specialist who is familiar with the hazards and the relevant regulations.
The device can be fastened to a truss or similar rigging structure. The device must never be fixed swinging
freely in the room.
1
The rigging structure must support at least 10 times the weight of all fixtures to be installed on it.
2
Block access below the work area and work from a stable platform when installing the device.
3
Use rigging hardware that is compatible with the structure and capable of bearing the weight of the
device. Please refer to the "Accessories" section for a list of suitable rigging hardware.
4
Secure the device with a safety bond or other secondary attachment. This secondary safety attachment
must be sufficiently dimensioned in accordance with the latest industrial safety regulations and
constructed in a way that no part of the installation can fall down if the main attachment fails. Pull the
safety bond through the safety eyelet and fasten it in such a way that, in the event of a fall, the maximum
drop distance of the device will not exceed 20 cm.
5
To align the device, release the fixation screws at the mounting bracket, adjust the desired inclination
angle and retighten the fixation screws.
6
After installation, the device requires inspections periodically to prevent the possibility of rot, deformation
and looseness.
17/24
00111167, Version 4.0

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

52202176

Inhaltsverzeichnis