Zendure SolarFlow 2400 AC+ Bedienungsanleitung Seite 27

EN
To use power above 2400W, follow the in-app instructions to complete the required steps.
(1) User must ensure electrical circuits are unmodified and certified by an electrician
(2) User guarantees authenticity and completeness of uploaded electrician-signed contracts
(3) Zendure is only liable for device quality/safety. The user and the electrician they hire shall bear full responsibility
and consequences for any power outages, personal injuries, or property damage resulting from non-compliance
with installation standards, lack of qualifications of the electrician, or improper use.
When exceeding the limits of plug-and-play regulations
• National Standards
Select the national standard applicable to the equipment installation site. Once configured, the equipment will
operate with voltage and frequency values that comply with the selected national standard.
• Base Load and Charging Settings
The charging and discharging power plan from 0:00 to 24:00. A maximum of 10 tasks can be set simultaneously.
• Battery Settings
Adjust all energy storage devices' battery discharge limit and charging limit.
2. General Setting
• Device Management
You can add or remove all devices within the system here.
When multiple energy storage devices are in operation, the exception handling logic is as follows:
offline devices will actively shut down their output to 0W, and the remaining online devices will actively take over
their target power.
Multiple energy storage devices can be added, a maximum of one Smart Meter can be added, and multiple smart
appliances can be added.
• System Information
You can modify the name of the energy storage system here.
26
When exceeding 2400w