Before First Use; User Manual - Princess Ese Pod Benutzerhandbuch

or defects.
• Do not make unauthorized adjustments to the appliance; this
may affect safety and warranty.
• Only use accessory attachments recommended by the
manufacturer.
• Do not immerse the appliance, cord, or plug in water or other
liquids.
• There is a sharp needle in the capsule adaptor. Do not touch
this area after removing the adaptor.
• Scalding may occur if the lid is removed during the brewing
cycle.
NOTICE
Risk of damaging the appliance:
• Never use aggressive chemical cleaning agents that can
damage the appliance when cleaning the appliance.
• Keep the appliance and cord away from heat, direct sunlight,
water, moisture, sharp edges etc.
6 CAUTION
• Do not operate the machine with an empty water tank C
• Do not open the sliding handle A
brewing coffee.
• Thoroughly rinse out the water tank C
before using it for the first time. Clean the appliance using a
damp cloth only.

BEFORE FIRST USE

1. Take all parts out of the box.
2. Check if anything is missing or broken.
3. Put the machine on a flat, dry surface near a power socket.
Fill the water tank C
y
Option 1 – without removing the tank:
1. Open the top lid A
4
.
2. Pour in room temperature drinking water. Do not use hot water, tap water, or other liquids.
3. Close the lid.
Option 2 – by removing the tank:
1. Remove the water tank C y from the frame C r
2. Rinse it with clean water.
3. Fill it with room temperature drinking water up to the MAX line.
4. Put the tank back and make sure it fits firmly.
© Princess | ESE POD Coffee Machine
y
while the machine is
1
with fresh water
y
.
6 | 01.249420.01.001
Flush the machine (First use or after long pause)
1. Make sure the water tank C
2. Close the sliding handle A
3. Place a large cup (at least 250 ml) under the coffee spout B
4. Plug in the machine.
5. Press the power button A
6. Press the brew button A
7. Wait until the water stops flowing.
8. Open the sliding handle A
USE
Use of Water Tank
1. Remove the water tank lid C
2. Remove the water tank C
3. Fill the tank with room temperature drinking water. Do not use hot water, tap water, or other liquids. Do
not fill above the MAX line.
4. Place the water tank C
5. Close the water tank lid C
Preheating
1. After filling the water tank, plug in the power cord.
2. Press power button A
3. The two buttons will flash blue while heating (about 1 minute).
4. When the buttons stay blue, the machine is ready to brew.
.
Pod Loading
1. Open the sliding door A
2. Insert the coffee pod into the capsule window (not numbered, but located inside the sliding door).
3. Close the sliding door A
Menu
Power
Espresso
Lungo
Coffee Brewing
1. Put a cup under the coffee spout B
2. Choose your coffee size based on your preference:
Lungo: ~45 seconds, 40–50 ml
•
Espresso: ~25 seconds, 20–30 ml
•
3. This machine does not have a flow meter. The amount of coffee depends on how long the pump runs.

User manual

is full and firmly in place.
y
. (Do not insert a capsule.)
1
q
.
. Wait ~45 seconds until the lights stop blinking.
3
3
to start flushing.
and empty the cup.
1
t
.
y
.
back into its position.
y
t
.
3
to start heating.
9
.
9
. The machine is now ready to brew.
q
.
7