Lenz Digital plus STANDARD Informationen Seite 27

27
Important advice:
The constant braking distance is only effective if the running notch is altered to 0. If the running
E
notch is decreased from e.g. 28 to 10, the speed-dependent delay from CV4 becomes effective.
While the shunting speed is switched off (default setting F3), the constant braking distance is
disabled and the delay from CV4 becomes effective.
The constant braking distance is also disabled if the delays set in the decoder are disabled by
means of the corresponding function.
The two latter features can also be used sensibly if you wish to interrupt a current braking process
prematurely.
The constant braking distance does not work if the layout is operated in analogue DC mode.
5.6 Shunting speed
The shunting speed halves the speed. This facilitates particularly sensitive control of the shunting
process. Use function 3 (ex-works setting, can be altered in CV59) to enable and disable the
shunting speed. If the shunting speed is enabled, the constant braking distance is disabled. The
shunting speed is enabled as long as the function is active.
5.7 Allocating function outputs to the functions of the digital system (mapping)
Here you can define which function of the digital system is used to switch the function outputs A, B,
and C on or off. The outputs A, B and C can be allocated to function F0 (direction-dependent) or
functions F1 to F8 as desired. This is allocated in CVs 33 to 46.
5.8 Lighting effect at function outputs
The lighting effect for the function outputs A and B is set in CV60 and for the function output C in
CV62. If you wish to switch the effects with a function of the digital system, you can make the