Kemper KTS ComLog module Bedienungsanleitung Seite 15

Specifications
Height x Width x Depth
Weight
Material
Voltage input
Frequency
Voltage output
Current consumption (I)
Current output (I)
Protection class
Permissible operating temperature
Specifications
Medium
Parameters
Protocol
2
Mounting and installation
Note!
For purposes of maintenance and repair, keep a
minimum clearance of 200mm in all directions.
General
1
The device is electrically wired.
•
Preparation
2
• First check the supplied materials for their
completeness.
Unit ComLog
[mm] 45 x 99 x 115
[kg] 0,15
Polyamid / VO
[V] 9-26 DC
[Hz] -
[V] -
[A] 0,1
[A] -
IP 20
[°C] 0-60
External bus
Modbus-RTU Salve
Mounting
3
•
•
© www.kemper-olpe.de – 03.2020 / K410095502001-00 – 15 /24
Power pack
90 x 22,5 x 84
0,15
-
85-264 AC
47-63
24 ± 1%
0,8 (100V AC) | 0,4 (240V AC)
1,25 (-25 °C...55 °C)
IP 20
0-60
internal bus
RS485 semiduplex
9600 baud, 8N1
Modbus-RTU Master
Look for a suitable mounting position and
fasten the housing at the intended installation
location.
Subsequently connect the controllers of the
KTS-ThermoBox(es) to each other via bus cable
and to the ComLog module as illustrated in
the following figure. To do that, you need to
remove the upper part of the housing.