Operating Safety; Operator Safety While Using Internal Combustion Engines - WACKER PT2R Betriebsanleitung

PT2R
1.3

Operating Safety

Familiarity and proper training are required for the safe operation of equipment! Equipment operated improperly or by
untrained personnel can be dangerous! Read the operating instructions contained in both this manual and the engine
manual and familiarize yourself with the location and proper use of all controls.
NEVER allow improperly trained people to operate
this equipment. People operating this equipment
must be familiar with the potential risks and haz-
ards associated with it.
NEVER touch engine or muffler while pump is
operating or immediately after it has been turned
off. These areas get hot and may cause burns.
NEVER use accessories or attachments which are
not recommended by WACKER for this equip-
ment. Damage to equipment and/or injury to user
may result.
NEVER pump volatile, flammable or low flash point
fluids. These fluids could ignite or explode.
NEVER pump corrosive chemicals or water con-
taining toxic substances. These fluids could create
serious health and environmental hazards. Con-
tact local authorities for assistance.
NEVER open priming plug when pump is hot.
Never loosen or remove inlet or discharge hose
fittings when pump is hot. Hot water inside could
be pressurized much like the radiator on an auto-
mobile. Allow pump to cool to the touch before
loosening plug and before loosening or removing
inlet or discharge hose fittings.
1.4

Operator Safety while using Internal Combustion Engines

Internal combustion engines present special hazards during operation and fueling! Failure to follow the safety
guidelines described below could result in severe injury or death.
DO NOT smoke while operating pump.
DO NOT smoke when refueling engine.
DO NOT refuel hot or running engine.
DO NOT refuel engine near open flame.
! WARNING
NEVER open pump housing cover while pump is
operating or start pump with the cover off. The
rotating impeller inside the pump can cut or sever
objects caught in it.
NEVER block or restrict flow from inlet line or
discharge line. Remove kinks from discharge line
before starting pump. Operation with a blocked
inlet line or discharge line can cause water inside
pump to overheat.
ALWAYS read, understand, and follow proce-
dures in Operator's Manual before attempting to
operate equipment.
ALWAYS be sure operator is familiar with proper
safety precautions and operation techniques be-
fore using pump.
ALWAYS be sure pump is on a firm, level surface
and will not tip, roll, slide, or fall while operating.
ALWAYS close fuel valve on engines equipped with
one, when pump is not being operated.
ALWAYS store equipment properly when it is not
being used. Equipment should be stored in a clean,
dry location out of the reach of children.
! WARNING
DO NOT spill fuel when refueling engine.
DO NOT operate near open flames.
ALWAYS refill fuel tank in well-ventilated area.
ALWAYS replace fuel tank cap after refueling.
OPERATION 1A
1A-3