Fitting Guide Bar And Chain; Chain Oil; Start/Stop - Texas A/S TSE 2040 Benutzerhandbuch

5. Fitting guide bar and chain

1. Remove the side cover (Fig. 3).
2. Put the chain around the nose wheel on the guide bar. Once the chain has good contact
with the nose wheel, put the guide bar into the engine unit, and position the chain on the
guide bar and around the chain wheel.
Ensure that the chain is facing the correct way "forward" (Fig. 8)
3. Fit the side cover.
4. Tighten the cover nut using fingers.
5. Lift the guide bar tip and tighten the chain using the tension screw on the side cover
(TSE2040) or manually with tool (TSE2010)
The chain must be tightened enough so that you can just lift a link free of the track on
the guide bar.
6. Safely secure the guide bar and side cover.

6. Chain oil

Always use chain oil to lubricate the guide bar and chain. Standard engine oil is not suitable
for this purpose.
We recommend Texas Chain Oil (product number: 90406590), which has the correct
viscosity. Remove the oil tank cover (Fig. 1-14) and fill with chain oil. Always clean around
the oil lid!
Check the oil level in the oil glass (Fig. 1-15) on the left side of the chainsaw every 15 min.
The amount of oil must never be less than the minimum mark, otherwise there is a risk that
the chain is not lubricated, which may lead to it becoming damaged.
For extra lubrication, use the oil hole (Fig. 1-B) on the guide bar's tip. Use a disposable
syringe and put the oil in the oil hole, while at the same time you pull the chain.
Always ensure that power is disconnected and that the chain brake (Fig. 1-3) is deactivated.
The cable holder (Fig. 1-8) must be used to minimize the tension in the power cable on the
chainsaw.

7. Start/stop

1. To start the chainsaw, activate the On/Off switch (Fig. 1-13).
2. You must hold in the safety button (Fig. 1-11) on the handle's left side before the
chainsaw can start.
3. The chainsaw will stop if you release the On/Off switch.
4. The chain brake handle must always be pulled back during use.
5. Check that the chain is getting lubricated. First time start without the oil lid fitted, can
help the feed the oil to the chain. Remember to fix the lid again!
6. Hold the chainsaw like shown on Fig. 8
14