VEVOR RT150CTW4 Bedienungsanleitung Seite 21

Too difficult to change from C to F?
When the air conditioning turned off, long press the [ mode] + [▼] 5s to enter the
parameter setting interface, the parameter code is displayed in the time zone and
the parameter code is flashing. Adjust the key [▼] when the parameter code is P6.
When the parameter code is flashing, press the key [▼] to adjust, then press the
mode key to save, then turn on to start the machine.
Installation Instructions
Step One:
Remove the cover of Wire controller box.
Step Two:
Secure the back cover with screws.
Step Three:
According to the drawing install two screws one by one.
Step Four:
Finally, the wire controller is buckled on the back cover and the installation is
completed
- 20 -