Mounting; Power Supply; Lens Mounting; Mounting Of The Video Cable - Abus TVCC20000 Bedienungsanleitung

6. Mounting

6.1 Power supply

Before you start with the installation please make sure that the main voltage and the nominal
voltage of the camera comply together.
(1) TVCC20000, TVCC20010, TVCC20020,
TVCC20030, TVCC20040
(1) TVCC20000, TVCC20010, TVCC20020, TVCC20030 and TVCC20040 are run by a
12VDC power supply. In order to connect a 12VDC power supply (DC Connector 5.5mm x
2.1mm) to the camera you have to first install the included connector cable. Therefore you
need to press the pins and insert the cable ends into the terminals.
(2) TVCC20510, TVCC20520, TVCC20530 and TVCC20540 are run by a 110~240VAC power
supply (preinstalled cable).

6.2 Lens mounting

The camera is designated for lenses with CS-Mount. A lens with C-Mount can be
mounted with the enclosed lens adapter ring.
Before a lens with C-Mount can be mounted, please make sure that the lens adapter
ring is mounted on the camera. Otherwise you may damage the image sensor.
For lenses with DC-drive the connector for the lens cable is on the right side of the
camera. The lens type is identified automatically by the camera (except TVCC20000).
A lens with DC-drive is recommended for an optimal image quality.

6.3 Mounting of the video cable

To connect the video signal of the camera with a monitor or recorder, use a coaxial cable of the
type RG59 with BNC-Connector (male) at the "VIDEO-OUT" connector.
The cable length up to the next device should not rise 100 meters.
(2) TVCC20510, TVCC20520, TVCC20530,
TVCC20540
20