Inhaltsverzeichnis
Werbung
3. Mounting/installation
IMPORTANT!
The camera must be disconnected from the power supply during installation.
3.1.
HDCC34011
Glue the drilling template provided where you intend to install the camera. Loosen the screws on the
locking plate. Use the wall plugs and screws provided to mount the camera base plate in place.
If the cable is to be routed through the side, do not fully mount the camera base plate at
this stage, so that the camera cable can still be fed through.
Lift the camera and cap onto the camera base plate and lock in position using the locking plate and
screw.
Alignment
Loosen the screw on the locking plate slightly to
adjust the position of the camera.
7. Panning: 0–360°
8. Tilting: 0–75°
9. Rotating: 0–360°
22
English
Werbung
Inhaltsverzeichnis
