Performing Initial Setup - Sonoro RELAX SO-810 Bedienungsanleitung

3.5

Performing initial setup

When RELAX is powered on for the first time, the "Setup Wizard"
appears on the display. Follow the instructions below to configure some
basic settings.
1. When the "Setup Wizard" is displayed, press + or – on the remote control
(or rotate the navigation knob) to select "YES" and then press OK to
start the setup.
2. You are then prompted to select:
▪ Language (to be used in the display)
▪ Time format (12 or 24-hour)
▪ Source of auto update (Update from radio, Internet or no update).
Depending on the selection you have made, follow the instructions on
the display to further set up date and time, time zone, daylight saving
or wireless network. Rotate the navigation knob on RELAX or press
the navigation buttons on the remote control to make selections and
then press OK to confirm (see chapter "Using the menus").
When Update from Internet is selected, Wi-Fi connection must be
first established. When entering the key of your wireless network,
rotate the navigation knob on RELAX or press the navigation buttons
on the remote control to select a character and then press OK to
confirm. To delete the last entry, select [BKSP]. To cancel entering
the key, select [CANCEL]. To confirm the entered key, select [OK].
82
© sonoro audio GmbH 2017