Maintenance And Service; Starting Operation; Maintenance And Cleaning - Bosch PRIO Lithium-Ion Bedienungsanleitung

OBJ_BUCH-113-001.book Page 16 Thursday, October 19, 2006 1:28 PM
For the working of all
wooden materials
For coarse-sanding, e. g. of
rough, unplaned beams and
boards
For face sanding and planing
small irregularities
For finish and fine sanding of
hard woods
For the working of
paint/enamel coats or
primers and fillers
For sanding off paint
For sanding primer
For final sanding of primers
before coating
For reworking or polishing, especially of metal and
stone, use fleece/polishing cloth pad.
Depending on the desired surface quality of the work-
piece, different fleece types or polishing cloth pads are
to be used.
Replacing the Sanding Plate
(see figure D)
The supplied sanding plate 4 is fitted with Velcro back-
ing and can be replaced. To remove the sanding plate
4, grasp it at one of the tips and pull it off.
Operation

Starting Operation

Switching On and Off
Press the On/Off switch 1 to start the machine.
To switch off the machine, press the On/Off switch 1
again.
Battery Charge-control Indication
The battery charge-control indication 2
indicates the charge condition of the bat-
tery during operation and consists of 2
green LEDs and a red LED.
16 | English
Grain size LED
Continuous lighting, green-green-red
Continuous lighting, green-red
Flashing light, red (flash frequency
40—180
increases with dropping capacity)
Operating Instructions
coarse 40
Wait until the machine has come to a stand-
medium 80, 120
still before placing it down.
The removal capacity during sanding is mainly deter-
fine 180
mined by the selection of the sanding sheet.
Only flawless sanding sheets achieve good sanding
capacity and extend the service life of the machine.
Pay attention to apply uniform sanding pressure; this
increases the working life of the sanding sheets.
40—180
Intensifiying the sanding pressure does not lead to an
coarse 40
increase of the sanding capacity, but to increased wear
of the machine and the sanding sheet.
medium 80, 120
For precise on-the-spot sanding of edges, corners and
hard to reach areas, it is also possible to work only with
fine 180
the tip or an edge of the sanding plate.
A sanding sheet that has been used for metal should
not be used for other materials.
Use only original Bosch sanding accessories.

Maintenance and Service

Maintenance and Cleaning

For safe and proper working, always keep the
machine and ventilation slots clean.
When the battery is no longer operative, please refer to
an authorised after-sales service agent for Bosch
power tools.
If the machine should fail despite the care taken in man-
ufacturing and testing procedures, repair should be
carried out by an after-sales service centre for Bosch
power tools.
In all correspondence and spare parts order, please
always include the 10-digit article number given on the
type plate of the machine.
Capacity
≥ 50%
25—50%
≤ 25%
2 609 001 622 • 19.10.06