Functional Description; Technical Data - Bosch PRIO Lithium-Ion Bedienungsanleitung

OBJ_BUCH-113-001.book Page 14 Thursday, October 19, 2006 1:28 PM
Battery Charger
Keep the battery charger away from rain or
moisture. Penetration of water in the battery
charger increases the risk of an electric shock.
Do not charge other batteries. The battery
charger is suitable only for charging Bosch lithium
ion batteries within the listed voltage range. Other-
wise there is danger of fire and explosion.
Keep the battery charger clean. Contamination
can lead to danger of an electric shock.
Before each use, check the battery charger,
cable and plug. If damage is detected, do not
use the battery charger. Never open the bat-
tery charger yourself. Have repairs performed
only by a qualified technician and only using
original spare parts. Damaged battery chargers,
cables and plugs increase the risk of an electric
shock.
Do not operate the battery charger on easily
inflammable surfaces (e. g., paper, textiles,
etc.) or surroundings. The heating of the battery
charger during the charging process can pose a fire
hazard.

Functional Description

Read all safety warnings and all
instructions. Failure to follow the warn-
ings and instructions may result in electric
shock, fire and/or serious injury.
Intended Use
The machine is intended for dry sanding and polishing
of wood, filler and coated surfaces. It is especially suit-
able for profiles, corners or hard to reach locations.
Product Features
The numbering of the product features refers to the
illustration of the machine on the graphics page.
1 On/Off switch
2 Battery charge-control indicator
3 Sanding sheet*
4 Sanding plate
5 Battery charger
6 Charge connector
7 Outlet piece
8 Dust protection cap
9 Extraction adapter*
10 Vacuum hose*
*The accessories illustrated or described are not
included as standard delivery.
14 | English

Technical Data

Cordless Multi Sander
Article number
Rated voltage
No-load speed
Orbital stroke rate
Sanding sheet surface
Orbit diameter
Weight according to
EPTA-Procedure 01/2003
Battery
Capacity
Battery Charger
Charging time
Please observe the article number on the type plate of your
machine. The trade names of the individual machines may
vary.
Noise/Vibration Information
Measured values determined according to EN 60745.
Typically the A-weighted sound pressure level of the
machine is 76 dB(A). Uncertainty K=3 dB.
The noise level when working can exceed 85 dB(A).
Wear hearing protection!
Overall vibrational value (vector sum of three direc-
tions) determined according to EN 60745:
Vibrational emission value a
2
K=1.5 m/s .
The vibration emission level given in
WARNING
this information sheet has been meas-
ured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with
another.
The vibration emission level will vary because of the
ways in which a power tool can be used and may
increase above the level given in this information sheet.
This could lead to a significant underestimate of expo-
sure when the tool is used regularly in such a way.
Note: To be accurate, an estimation of the level of
exposure to vibration experienced during a given period
of work should also take into account the times when
the tool is switched off and when it is running but not
actually doing the job. This may significantly reduce the
exposure level over the total working period.
PRIO
Lithium-Ion
3 603 J19 7..
V= 7.2
rpm 10000
opm 20000
2
cm 104
mm 1.2
kg 0.7
Li-Ion
Ah 1.0
33 ±3
min
2
=5.5 m/s , uncertainty
h
2 609 001 622 • 19.10.06