Inhaltsverzeichnis
Werbung
NETWORK SETTINGS (Network Settings)
Use the UP and DOWN buttons to select the "Network Settings" menu item and confirm by pressing ENTER. The required sub-menu can be selected
by using the UP and DOWN buttons, confirm with ENTER and adjust the settings as needed.
Network Settings
Sub-menu items and explanations:
Network Settings
IP Address
SubNet Mask
ArtNet Universe
SYSTEM SETTINGS AND INFORMATION (Settings & Info)
Use the UP and DOWN buttons to select the "Settings & Info" menu item and confirm by pressing ENTER. The required sub-menu can be selected by
using the UP and DOWN buttons, confirm with ENTER and adjust the settings as needed and read the relevant information.
Settings & Info
Sub-menu items and explanations:
Settings & Info
Display on/off
Signal Interrupt
Software Version
Operation Hours
Test
Factory Reset
Esc
DE
HINWEIS
Wenige Sekunden nachdem der Scheinwerfer korrekt am Stromnetz angeschlossen wird, ist er betriebsbereit und startet in der Betriebsart, die zuvor
angewählt war. Beim Start wird kurz die Firmware Version im Display angezeigt.
BETRIEBSART EINSTELLEN (Operation Mode)
Wählen Sie mit Hilfe der Tasten UP und DOWN den Menüpunkt „Operation Mode" aus und bestätigen mit ENTER. Die gewünschte Betriebsart wählen
Sie nun wiederum mit Hilfe der Tasten UP und DOWN aus und bestätigen mit ENTER. Zum Verlassen des Untermenüs auf MODE drücken.
Betriebsarten: Manual Mode, DMX Mode, Art-Net Mode, Kling-Net Mode, Slave Mode, Auto Mode.
Operation Mode
Untermenüpunkte und Erläuterungen:
18
Number block 1
Number block 2
Number block 3
Number block 4
Number block 1
Number block 2
Number block 3
Number block 4
Number block 1
Number block 2
Number block 3
For example:
Display lighting
operation status in
case of signal interruption
Firmware Version
Operating time in hours and minutes
after switching on
Testing all LEDs
Reset to factory setting
When exiting the menu level
000 - 255
Select number block using UP and DOWN, confirm with ENTER, select
address using UP and DOWN, confirm with ENTER
000 - 255
000 - 255
000 - 255
000 - 255
Select number block using UP and DOWN, confirm with ENTER, select
number using UP and DOWN, confirm with ENTER
000 - 255
000 - 255
000 - 255
000 - 255
Select number block using UP and DOWN, confirm with ENTER, select
universe using UP and DOWN, confirm with ENTER
00 - 15
00 - 15
Universe 1
000
Universe 17
000
on
permanently on
deactivation after approx. 20
off
seconds of inactivity
Hold
last command is held
Auto
activates the auto program
Blackout
activates Blackout
Firmware x
xx:xx
on
Starting test sequences
off
Stopping test sequences
on
Starting reset operation
off
Do not perform the reset operation
00
00
01
00
confirm with ENTER
confirm with ENTER
Display with ENTER
Display with ENTER
confirm with ENTER
confirm with ENTER
confirm with ENTER
Werbung
Inhaltsverzeichnis
