Turn Target On/Off Using Adonis - Guntermann & Drunck HardBoot CCX Installation Und Bedienung

Guntermann & Drunck GmbH
4

Turn Target On/Off using AdonIS

In the CATCenter Adonis Operation menu, you can turn the currently active
target on/off in the line 'TARGET POWER'.
The base requirements for this function are:

At least one HardBoot must be connected to the CATCenter to supply
power.

The corresponding settings must have been set for this target in the
'CONFIG-Menu -> Power' (see
To turn off a target, carry out the following steps:
1. Access AdonIS by pressing the key combination (default):
CTRL + NUM
2. Access the OPERATION menu by pressing the
3. Move the cursor to the entry 'TARGET POWER' and press
the I key.
By pressing the ENTER
turned off.
After the target has been turned off, the entry in the 'TARGET POWER' line
changes from On to Off.
Follow the same process to turn on a target that is not running.
Alternatively, the function can be called from the SELECT menu using the
hotkey combination
key, the selected (and running) target is automatically
CTRL + I.
Page 15
Installation and Configuration Manual
Chapter 3).
F9 key.
HardBoot CCX
ENTER or