Intended Use - Becker Centronic SensorControl SC211-II Montage & Betriebsanleitung

The SC211-II is intended solely for the operation of an open, half-closed
(semi-cassette), or fully closed (cassette) articulated-arm awning.
For safety reasons, the SC211-II may only be operated with a tubular drive
(dia. 45, dia. 58) of type C PSF(+) with serial numbers 0902... and above, as
well as with the VC420-II and the VC470-II. The operation of two or more artic-
ulated-arm awnings with one SC211-II is not permitted.
The SC211-II is compatible with the Centronic SunWindControl SWC241-II
hand-held transmitter. Operation using other sun protection controls from the
Centronic range is not recommended.
Use for other purposes or for purposes beyond the above constitutes im-
proper use.
• Please note that radio-controlled systems may not be used in areas with
a high risk of interference (e.g. hospitals, airports).
• The remote control is intended solely for use with equipment and sys-
tems in which malfunctions in the transmitter or receiver would not pose
any risk to persons, animals or property, or which contain safety devices
to eliminate such risks.
• The operator is not protected from interference from other telecommu-
nications systems and terminal equipment (e.g. even from radio-con-
trolled systems which are properly operated in the same frequency
range).
• Only connect radio receivers to devices and systems approved by the
manufacturer.
• Radio-controlled systems transmitting on
the same frequency may cause reception in-
terference.
• Note that the range of the radio signal is lim-
ited by legislation as well as by design.

Intended use

19 - en