Maintenance And Cleaning; Maintenance And Care; Storage; Guarantee - ATIKA RT 350 Bedienungsanleitung

2. Press the slide switch (10) at the lower end of the upper
trimmer part (1) to the left while pulling the upper trimmer
part out.
3. Turn the upper part (1) by 180° and plug it into the lower
trimmer part (2) until the slide switch engages.
Guide the product around trees and shrubs so that the plants
are not damaged.
Caution! Damaged plants may die off.
Do not guide the cutting thread directly at walls and paving
stones. Otherwise it will prematurely wear off.
Thread follow-up
During trimming, the cutting thread wears (becomes shorter) or
it may tear off so that it can no longer cut grass.
Shortly press the running lawn trimmer against firm ground.
This will extend the cutting thread (by approx. 4 cm). If the
cutting thread exceeds the maximum cutting diameter it will be
shortened by the integrated knife within the protective hood.

Maintenance and cleaning

Before each maintenance and cleaning
work :
- switch off device
- wait until the cutting thread is stationary.
- pull out main plug
For maintaining and cleaning, removed security devices must
unconditionally be mounted properly and proved again.
Use only original parts. Other parts can result in unexpected
damages and injuries.
Maintenance and repair work beyond this is only allowed to be
carried out by the manufacturer or authorized service staff.
Note the following to keep your lawn trimmer
functioning:
Clean all movable parts on a regular basis.
Remove dust and dirt with a cloth or a brush.
Do not clean the machine with running water or high-
pressure cleaners.
Do not use solvents for the synthetic parts (petrol, alcohol,
etc.) as these can damage the synthetic parts.
Replacing the thread spool
Replacing the thread spool -
1. Disconnect the mains plug.
2. Press together the both locking devices (16) at the spool
cover (12) and remove the latter.
3. Remove the thread spool (13) from the spool cover.
4. Remove dirt and grass residues.
5. Thread the both cutting thread ends (15) of the new thread
spool through the holes (17) of the spool cover provided for
this (each one end through one hole).
E
6. Firmly place the thread spool in the spool cover. Make sure
that the cutting threads are not caught and pull them
approx. 9 cm out of the spool.
7. Place the spool cover with thread spool on the spring (14)
and press it firmly down until the locking devices (16) of the
spool cover (12) securely click into place.

Storage

Remove the mains plug from
the socket.
Store unused equipment in a dry, locked place out of the
reach of children.
Place the protective cap (19) onto the thread knife (20).
Before a longer storage observe the following in order to
prolongate the service life of the machine and to guarantee
a smooth running operation:
− thoroughly clean the machine

Guarantee

We grant a guarantee of two years, commencing with the
•
day of delivery from the dealer's store, for material and
manufacturing faults.
Warranty claims, even during the warranty period, will not
•
be accepted for damages due to incorrect handling or
inadequate packaging during return of the devices or to a
non-observance of the operating instructions. Faulty parts
must be sent to our works, postage or freight free. We
reserve the right to decide upon free spare part delivery.
• Guarantee work will be completed by us or an authorised
servicing agency. Guarantee damage can only be
remedied by another firm with our explicit approval.
The warranty does not cover normal wearing of the thread
•
spool.
Guarantee is also granted if original spare parts are used.
•
Subject to changes in the interest of technical progress.
•
17
B