NAMCO Ridge Racer V Arcade Battle Betriebsanleitung Seite 62

8-4 Repacing the Amplifier PCB
1. Remove the floor plates.
2. Disconnect the connectors shown shaded in the diagram below.
3. To remove the Amplifier PCB from the locking supports, squeeze the tabs
of the support together and gently lift the PCB upwards. Repeat for each
support.
Locking support
Pliers
< To remove >
PC board
< To reinstall >
4. Reassemble in reverse order.
(see 5-3 page 37)
Click!
Page 62
Amplifier PC board
Connector