IFM Electronic efector 200 Bedienungsanleitung Seite 9

Setting of the sensitivity with moving objects
Activate the programming mode of the unit.
1
Press for about 2s until the red LED flashes.
The red LED goes out; the yellow and green LEDs flash alternately.
The unit is in the programming mode.
During the measurement (approx. 1s) allow at least two objects to
move through the sensing area of the lens.
2
Press once.
The yellow and green LEDs go out for approx. 1s,
then flash again alternately.
During the measurement (approx. 1s) allow at least two objects to
move through the sensing area of the lens.
3
Press once.
The yellow and green LEDs go out for approx. 1s,
then the green LED is on.
The unit is in the operating mode.
If the setting of the sensitivity is not possible (e.g. object signal
and background signal are about the same), the red LED flashes
after step 3 for approx. 2s. The unit then passes into the operat-
ing mode with the sensitivity being unchanged.
receiver
receiver
receiver
transmitter
transmitter
transmitter
9