Operation - IFM Electronic efector 200 Bedienungsanleitung

Setting of the maximum sensitivity
• Go into the programming mode (step 1).
• Interrupt the light beam.
• Press the setting button twice (see steps 2 and 3).
Locking/Unlocking:
Press for 10s.
Press for 10s.

Operation

Check the safe functioning of the through-beam sensor. Display by
LEDs and by the function-check output.
LED green is lit
LED yellow is lit
LED red is lit
LEDs
yellow + red
10
unit is ready for operation
output is switched
error in object detection, e.g. maladjustment,
soiling of the lenses
flashing alternately, 2 Hz: output short-circuited
flashing alternately, 1 Hz: internal malfunction
(output is not switched)
The red LED lights for a short time,
then the yellow and green LEDs
flash alternately;
after 10s the LEDs go out,
the unit is locked.
After 10s the LEDs go out,
locking is annulled.