Meister basic BFS 600 Originalbetriebsanleitung Seite 75

5413060-Farbspritz-man.qxd
paint container and hold down the
handle of the gun to ensure that the
paint flows out of the feed hose.
• Use a suitable solvent or cleaning
agent (usually water or white spirit)
and clean the feed hose, the inside of
the lid, the paint container, the seal
(6), the spray cap (5), the securing
ring and the spray nozzle. Carefully
clean the air inlet, but do not insert
objects into this opening. Then
remove all paint residue from the gun.
• Put a small amount of solvent or
water into the paint container. A small
amount will suffice. Put the spray gun
back together again and spray until
the paint container is clean.
Caution: The compressor, cable
and hose may not be spray
cleaned using solvent or water.
Note: If the solvent cannot be
sprayed properly, check to see
whether the air outlet is clean. If this
is blocked with paint, only air will
come out when you press the handle.
The air inlet can be accessed by
removing the spray cap and the
securing ring.
• The needle (7) must always be clean.
This applies to both the spray cap and
the securing ring. We recommend
treating the tip of the needle with a
drop of sewing machine oil before
storing the spray gun.
NOTE: Paint that has dried in the
spray gun will prevent it from
functioning properly. If you do not
observe this, the guarantee will be
voided.
CAUTION! After each use, carry
out the following tasks:
02.02.2010 12:07 Uhr
1. Empty any unused paint from the
paint container.
2. Clean the container thoroughly with
the thinner you have used.
3. Put a little thinner into the container
and spray using the spray gun until
only clean thinner exits the spray
gun.
4. Clean the suction pipe and the filter
with thinner.
5. Clean the basket and nozzle and
remove all remaining dirt or paint.
6. Hold the spray gun upside down and
apply a couple of drops of sewing
machine oil to both openings.
7. Switch the spray gun on briefly.
8. Keep the ventilation slots of the
device clean in order to prevent the
motor from overheating. Clean the
casing regularly with a soft cloth,
preferably after each use. The
ventilation slots must be free from
dust and dirt. If the dirt cannot be
removed, use a soft cloth dipped in
soapy water. Never use solvents such
as benzene, alcohol, ammoniac etc.
This solvents may attack the plastic
elements.
should not be disposed of in the
household waste! They are to be
collected separately, in
accordance with the
2002/96 EC directive for the
disposal of electrical and
electronic waste, and sent
for proper and environ-
mentally-friendly recycling.
Please discard power tools no longer
usable at a local collection point.
Collection and disposal of packaging
materials separately by types
complying with local rules and
regulations. For details, please contact
your municipal authority concerned.
Seite 75
CAUTION! Electrical and battery
operated units that no longer work
75