Assembly; Operating Instructions - Meister Basic Bfs 600 Originalbetriebsanleitung

5413060-Farbspritz-man.qxd
• Never carry the device using the
power cable. When unplugging the
device from the power, do not tug at
the cable, always use the plug. Keep
the power cable away from sharp
edges, oil and heat.
• When working, always ensure that
you are standing firmly and you are
well balanced!
• Unplug the device from the power
supply before carrying out any
maintenance or repair and before
replacing individual components.
• If you are using the device outdoors,
ensure you use an appropriate,
specially designed power cable
extension.
• Make sure you maintain a high level
of concentration when working. Use
common sense! Take a break if you
are tired.
• Repair work should only be carried
out by appropriately qualified
experts. When replacing individual
components, only use original parts
or parts that have been explicitly
recommended by the manufacturer in
order to prevent risks.
• Never use highly flammable liquids
with the device.
• Never clean the device using
flammable solvents.
DANGER! Risk of explosion
or fire when painting or
thinning! This could cause injury
and serious damage. Ensure there
are no potential sources of ignition
in the area, such as sparks, naked
flames, fire lighters and cigarettes.
72
02.02.2010 12:07 Uhr
inhaled! This may cause dizziness,
fainting or other types of poisoning!
cable. Risk of electric shock!
appropriate doctor.
7 – Assembly
Fix the holder (11) for the spray gun to
the side of the compressor (3) by
slotting the square knob into the recess
on the compressor (Fig. 2). Fix one end
of the pressure hose (4) to the outlet of
the compressor (Fig. 3) and the other
end to the inlet of the paint gun (Fig. 4).
Connect the compressor to the power
supply and switch it on by pushing the
On/Off button to the (10) ON position.
To switch the compressor off, push the
On/Off button to the OFF position.
8 – Operating instructions
Mixing the paint
• Step 1: First measure the viscosity of
• Step 2: Thinning the paint. If the
Seite 72
DANGER! Paints and thinners
may have a toxic effect if
DANGER! Never pull the plug out
of the socket by tugging the
CAUTION! In the event of injury,
immediately consult an
the paint. To do this, stir the paint well,
then dip the viscosity measurement
beaker (9) into the paint and fill to just
below the rim. Raise the beaker and
wait to see how long it takes until the
paint has drained completely (Fig. 5).
The maximum viscosity value for this
spray gun is 30 to 35 seconds.
value is lower than 30 seconds, you