Hama Basic Bedienungsanleitung Seite 5

@ Operating Instruction
The "Basic" energy cost meter allows you to find the
"power guzzling" devices in your home or office both
quickly and easily. By replacing these devices with
energy-saving devices (such as class A, A+, A++),you
can save money and make an important contribution
to the environment. Example: By replacing an older re-
frigerator (approx. 15years old) with an energy-saving
A++ device, you can save up to 300kWh annually or
up to EUR60 (based on a tariff of EUR0.20/kWh).
Readthe safety instructions and notes carefully
before using your energy cost meter.
Important safety instructions:
The voltage or power of the connected devices
must not exceed 230 V or 3,680 W. Please note the
information printed on the type plate of the connected
devices.
Make sure that the passed-through protective
conductor is not blocked. In the case of a fault, this
could result in fatal injury. Only connect the device to
an electrical socket that has been approved for the
device. The electrical socket must always be easily
accessible.
The device is not protected against drops or splashes
of water. Do not let the product come into contact with
rain, moisture or other liquids to avoid damaging the
device and to prevent injuries due to short circuits.
We do not recommend that you operate this device
in environments exposed to flammable gases, fumes
or dust. When cleaning the device, make sure that
it is disconnected from power. Do not operate this
device in a moist environment
itself is moist.
Never use or open a defective device. Repair work
may only be conducted by an authorised specialist. As
with all electronic devices, keep the device out of the
reach of children.
We shall not accept any liability for damage to materi-
als or injury to persons resulting from non-observance
of these safety instructions or improper use. The Basic
is not an approved method of calculating the power
costs between the power supply company and the
consumer.
4
4
or when the device
Getting started:
1. Button Functions:
MENU SET
o o
MENU: Switches to different displays
SET: Switches to "Basic settings" mode
. Changesthe selected place in the number
Allows you to switch between the values
0-9 incrementally
RST: Resets the device. All values for cost, tariffs
and kWh are saved
Note: The buttons
"Basic settings" mode
2. Display:
l. COST: Displays the total consumption up to
max.9,999.99(corresponds to the cost
since the last interruption in power)
2. TARIFF: Displays the set tariff up to
max. EUR 99.99/kWh
Displays the kilowatt hours up to
3. kWh:
max. 9999.99 kWh
(corresponds to the
consumption since the last
interruption in power)
+
as default values
and + only work in