Troubleshooting Guide - Homcom 820-448V90 Bedienungsanleitung

TROUBLE SHOOTING GUIDE
PROBLEM
Fire is not switching on.
Logs glow, but the flame effect does
not work.
The buttons are in the 'on' position,
but the heater does not work.
The unit makes a lot of noise.
There is a visible fame effect, but the
heater does not blow warm air.
Remote is not operating.
POSSIBLE CAUSE AND SUGGESTED
SOLUTION
1. Ensure the mains switch is on.
2. Ensure the unit is plugged into a standard
220-240V outlet.
3. Replace the fuse in the plug.
Check to see if the spinning motor is
working.
Turn all buttons to the 'OFF' position and
unplug the unit for 10 minutes. After 10
minutes, plug the unit back in-it should
operate normally
1.There may be a level of noise associated
with using this appliance. When the flame
effect is in use, the motor is used, which
may produce some noise that is
noticeable when there is no other
background noise.
2. When the heater is in use, there may be a
higher level of noise associated with the
heater due to the airflow required for heat
production.
1.Ensure the temperature setting is greater
than the room temperature.
2.Press the heater several times, ensuring
it is in the 'ON' position.
1.Repeatedly pressing buttons in rapid
succession may cause the transmitter to
malfunction. Use the remote control at a
slow and measured pace. Press the
remote control buttons gently.
2. Check the batteries and replace them if
needed.
29