HOMCOM 820-448V90 Bedienungsanleitung Seite 28

OPERATING INSTRUCTIONS
Power:
This button will put the appliance on standby, whilst allowing
you to view the flame effect through the screen. Pressing the
same button again will turn off all functions simultaneously.
Timer:
Press the button repeatedly to cycle through the available
options, which include 30 minutes, one hour, two hours, three
hours, four hours, five hours, six hours and 'off. The display will
show the corresponding time setting, such as '30' for 30
minutes or '3H' for three hours. Once the timer is set, the
fireplace will automatically turn off when the timer reaches zero
minutes. The current timer can be seen on the display. 'NONE'
indicates that the timer is currently off.
Flame:
This button controls the flame effect, so you can adjust the
flame to your desired level of intensity, Press the button to
increase or decrease the flame effect. Continue to press it to
cycle through the available settings.
The brightness levels of the flame are high, medium, low and
off. The display will indicate the current setting as L3, L2, L1 or
off, respectively.
Heater:
The default temperature is 72 °F(22°C).
Hold the heater button for five seconds. The display will flash -
press the button again to change the temperature. The setting
range is between 62-82°F(21-27°C).To change between °F
and°C, hold the power button for five seconds when the heater
is on. Once set, the display will flash five times
Weekly timer:
Use the timer button to turn on the weekly timer.
Plus:
Increase the time and temperature during the weekly timer
setting.
Minus:
Decrease the time and temperature during the weekly timer
setting
27