Jimmy bewinch R9 Pro Bedienungsanleitung Seite 8

Flushing before first use
Step 1 Fill raw water tank
Remove raw water tank cover, hold the handle of the raw water tank and lift it upward. Fill the
raw water tank with municipal tap water up to below handle and put it back to machine.
Step 2 Water purification start
Connect device to power supply to start purifying water, the water purification indicator "
up, when the water purification light goes out , it means that the water purification is completed.
Step 3 Turn on water cooling function
Keep pressing " " botton for 5 secods to turn of water cooling function. After water cooling
function is turned on, "
lights up.
Note:
When water cooling function is turned on for the first time, about 20 minutes after water purification start, there
will be small amount of water flow out from water outlet. It is normal phenomenon.
Step 4 Drain pure water cup
1. Empty pure water cup and put it back to machine to continue purifying. After pure water cup is
full, empty it again. After emptying pure water cup for 3 to 5 times, you can start using the
water purifier.
Pure water
cup
6
Raw water tank
cover
" indicator changes from semi bright to fully bright and "
Raw water
tank
" lights
" indicator