VEVOR BJS-25-RD-01 Bedienungsanleitung Seite 9

7.Put the Plastic Back Plate in the
Right mold.
NOT：If use the Metal Back Plate
(Size：44mm/58mm and 75mm)
that you need to put the Plastic
Washer first.
10.Take out the badge and the
operation complete.
8.Push the Right mold under
the Upper mold.
NOTE: the upper and lower
molds must be on the same
vertical line.
7
9. Hold the Armrest with one
hand and with the other hand
hold the Handle, then press
down until the bottom.
NOTE: It is OK that the PINS go
through the up plate of the
Upper Model.
ok
NG