VEVOR BJS-25-RD-01 Bedienungsanleitung Seite 8

How to make a badge
1.Prepare required materials.
4. Put Transparent Plastics Film in
the Left mold.
2.Put Tin Up Cover in the Left
mold
5. Push the Left mold under
the Upper mold.
NOTE: the upper and lower
molds must be on the same
vertical line.
6
3.Put White Paper in the
Left mold,
Note: If you want to make a
badge with a pattern, the white
paper needs to be replaced with
a patterned paper.
6. Hold the Armrest with one
hand and with the other hand
hold the Handle, then press
down until the bottom.
NOTE: It is OK that the PINS
don't go through the up plate of
the Upper Model.
ok
NG