VEVOR BJS-25-RD-01 Bedienungsanleitung Seite 11

Not tightly press the badge,
pressed in but not firm
Up mold unable to lift up after
pressing manufacture, blocked
2. Unsuitable paper thickness
3. Up mold screws loosen
1. The downward press is not in
place, not press to the bottom.
2. Paper is thinner
3. (Size: 44mm/58mm and 75mm
) Configured metal back
consumables do not place the
washer
1. Up and down mold position
deviated
2. The paper is incorrectly cut
round or blocked by a foreign
object.
9
2. Use the stipulated thickness
paper.
3. Place the up mold on the
machine body, use the
complimentary Allen key to fix
the screws in the up mold
internal hole center.
1. Need press to the bottom
when downward pressing.
2. Change to use a slightly
thicker paper.
3. Right side mold place 2mm
thickness washer when using
the metal back consumables.
Use a sharp tool (such as a
straight screwdriver) to align to
middle merge position clearance
which is between up and down
mold, and pry open with the
object like a hammer (Attention:
Just tap it, generally, it will not be
too tightened).