Sound Signal; Cleaning And Maintenance - Royal Catering Rcsco-01 Benutzerhandbuch

During operation, only the "Start/Stop" button will work, the other buttons will be
•
locked. (Press "Start/Stop" for more than 2 seconds to unlock the whole working process
and enter standby mode).
Comments:
a) In case of combined cooking, sensor and keep warm function, when the first set temperature
is reached, this temperature will automatically enter sensor mode. This principle allows you
to maintain a temperature difference between the inside of the cooked food and the
temperature in the oven cavity, ensuring better taste.
b) The timer function is not available for the combined sensor and hold function.
c) When a single function or combined function is completed, the device will beep for 1 second,
"END" will appear on the display and the "Start/Stop" indicator will flash. All LEDs will turn
off except the Power LED.

7) Sound signal:

a) An acoustic signal lasting 1 second means that the first set temperature has been reached or
all set functions have been completed.
b) A double beep indicates that the operation has been completed and the oven automatically
switches to sustain mode.
Protective element
If the oven temperature reaches unsafe levels, the electrical components will shut down and the
oven will stop working to prevent overheating.
3.4.

Cleaning and maintenance

a) Before each cleaning, adjustment, replacement of accessories, and when the device is not in use,
disconnect the power plug and cool the device completely.
b) Only agents that do not contain corrosive substances should be used to clean the surfaces.
c) Only mild cleaning agents intended for cleaning surfaces in contact with food may be used to clean the
device.
d) After each cleaning, all components should be dried thoroughly before the device is used again.
e) The device should be stored in a dry and cool place protected from moisture and direct sunlight.
f) It is prohibited to spray the device with a jet of water or immerse the device in water.
g) Please make sure that no water gets in through the ventilation holes in the housing.
h) Ventilation holes should be cleaned with a brush and compressed air.
i) The device should be regularly inspected for its technical efficiency and any damage.
j) Use a soft cloth for cleaning.
k) Do not use sharp and/or metal objects (e.g. a wire brush or a metal spatula) for cleaning, as they may
damage the surface of the material from which the device is made.
3.5. Troubleshooting
Problem: The oven does not heat up when turned on.
Make sure the timer is set.
•
Make sure the temperature is set.
•
Problem: There is a metallic sound when the oven is operating.
Do not attempt to disassemble the oven.
•
Contact service to check the fan.
•
EN