Pnp/Pci Configurations - Ecs Rx480-A Handbuch

42

PNP/PCI Configurations

These options configure how PnP (Plug and Play) and PCI expansion cards operate in
your system. Both the the ISA and PCI buses on the motherboard use system IRQs
(Interrup ReQuests) and DMAs (Direct Memory Access). You must set up the IRQ and
DMA assignments correctly through the PnP/PCI Configurations Setup utility for the
motherboard to work properly. Selecting PnP/PCI Configurations on the main program
screen displays this menu:
Reset Configuration Data (Disabled)
If you enable this item and restart the system, any Plug and Play configuration data
stored in the BIOS Setup is cleared from memory.
Resources Controlled By (Auto(ESCD))
You should leave this item at the default Auto (ESCD). Under this setting, the system
dynamically allocates resources to Plug and Play devices as they are required.
If you cannot get a legacy ISA (Industry Standard Architecture) expansion card to work
properly, you might be able to solve the problem by changing this item to Manual, and
then opening up the IRQ Resources submenu.
•
PCI/VGA Palette Snoop [Disabled]
This item is designed to overcome problems that can be caused by some non-standard
VGA cards. This board includes a built-in VGA system that does not require palette
snooping so you must leave this item disabled.
Assign IRQ For USB [Enabled]
Names the interrupt request (IRQ) line assigned to the USB on your system. Activity of
the selected IRQ always awakens the system.
Downloaded from www.Manualslib.com
Phoenix-AwardBIOS CMOS Setup Utility
Reset Configuration Data
Resources Controlled By
X
IRQ Resources
PCI/VGA Palette Snoop
Assign IRQ For USB
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
F5:Previous Values
IRQ Resources (Press Enter):In the IRQ Resources submenu, if you as-
sign an IRQ to Legacy ISA, then that Interrupt Request Line is reserved for a
legacy ISA expansion card. Press <Esc> to close the IRQ Resources submenu.
In the Memory Resources submenu, use the first item Reserved memory Base
to set the start address of the memory you want to reserve for the ISA
expansion card. Use the second item Reserved Memory Length to set the
amount of reserved memory. Press <Esc> to close the Memory Resources
submenu.
manuals search engine
PnP/PCI Configurations
Item Help
[Disabled]
Menu Level
[Auto(ESCD)]
Press Enter Default is Disabled. Select
Enabled to reset Extended
[Disabled] System Configuration Data
[Enabled]
ESCD) when you exit Setup
if you have installed a new
add-on and the system
reconfiguration has caused
such a serious conflict that
the OS cannot boot
F6:Fail-Safe Defaults F7:Optimized Defaults
Using BIOS