Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis
  • English

    • Português

      • Հայերեն

        • Français

          • Español

            • Bahasa Indonesia

              • 汉语

                • 조선말/한국어

                  Werbung

                  Verfügbare Sprachen
                  • DE

                  Verfügbare Sprachen

                  • DEUTSCH, seite 19
                  Disclaimer
                  The information in this document is subject to change without notice. The
                  manufacturer makes no representations or warranties with respect to the contents
                  hereof and specifically disclaims any implied warranties of merchantability or
                  fitness for any particular purpose. The manufacturer reserves the right to revise this
                  publication and to make changes from time to time in the content hereof without
                  obligation of the manufacturer to notify any person of such revision or changes.
                  Federal Communications Commission (FCC)
                  This equipment has been tested and found to comply with the limits for a Class B
                  digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
                  provide reasonable protection against harmful interference in a residential
                  installation. This equipment generates, uses, and can radiate radio frequency
                  energy and, if not installed and used in accordance with the instructions, may cause
                  harmful interference to radio communications. However, there is no guarantee that
                  interference will not occur in a particular installation. If this equipment does cause
                  harmful interference to radio or television reception, which can be determined by
                  turning the equipment off and on, the user is encouraged to try to correct the
                  interference by one or more of the following measures:
                  Reorient or relocate the receiving antenna
                  Increase the separation between the equipment and the receiver
                  Connect the equipment onto an outlet on a circuit different from that to
                  which the receiver is connected
                  Consult the dealer or an experienced radio/TV technician for help
                  Shielded interconnect cables and a shielded AC power cable must be employed with
                  this equipment to ensure compliance with the pertinent RF emission limits
                  governing this device. Changes or modifications not expressly approved by the
                  system's manufacturer could void the user's authority to operate the equipment.
                  Declaration of Conformity
                  This device complies with part 15 of the FCC rules. Operation is subject to the follow-
                  ing conditions:
                  This device may not cause harmful interference.
                  This device must accept any interference received, including interference
                  that may cause undesired operation.
                  This device is in conformity with the following EC/EMC directives:
                  Limits and methods of mesurement of radio disturbance char-
                  EN 55022
                  acteristics of information technology equipment
                  EN 61000-3-2
                  Disturbances in supply systems caused
                  Disturbances in supply systems caused by household appli-
                  EN 61000-3-3
                  ances and similar electrical equipment " Voltage fluctuations"
                  EN 55024
                  Information technology equipment-Immunity characteristics-
                  Limits and methods of measurement
                  EN 60950
                  Safety for information technology equipment including electri-
                  cal business equipment
                  CE marking
                  H110M-C43/H110M-C33 USER MANUAL
                  ®

                  Werbung

                  Inhaltsverzeichnis
                  loading

                  Inhaltszusammenfassung für ECS H110M-C43

                  • Seite 5: Motherboard Components

                    Motherboard Components H110M-C43/H110M-C33 USER MANUAL...
                  • Seite 8 System Ground Power +12V Sensor SYS_FAN1~2 System Ground Power +12V System Ground Sensor Power +12V Sensor Ground LAD1 RESERVE1 LAD2 SERIRQ SMBDATA Ground SMBCLK Ground TPM_CLK LPCPD# LFRAME# Ground LRESET# 3VSB LAD3 RESERVE0 VCC3 LAD0 Signal Power +5V H110M-C43/H110M-C33 USER MANUAL...
                  • Seite 19: Deutsch

                    1-2. Lösen Sie durch eine Drehung die Pushpins 1-1. Lösen Sie den Hebel vom des CPU-Kühlers und richten Sie diese mit den CPU-Sockel. entsprechenden Löchern Kunststo abdeckung und richten Sie die aus und drücken Sie die Kerbe der CPU mit der entsprechenden Pushpins nach unten bis sie einrasten.
                  • Seite 20 b. Schließen Sie die SATA-Stromanschlusskabel a. Schließen Sie das/die SATA-Kabel der an den SATA-Geräten an c. Stecken Sie das 24-Pin-Stromversorgungskabel d. Stecken Sie das 4-Pin-Stromversorgungsk in den entsprechenden Anschluss auf der abel in den entsprechenden Anschluss auf Der ATX_12V 4-Pin-Anschluss versorgt die CPU mit der einen Seite des 24-Pin- Stromversorgungskabels am ATX-Anschluss der einen Seite des 4-Pin-Stromversorgungska...
                  • Seite 21: Russian

                    1-1. 1-2. /DD /DD /DD 3-1. 3-2.
                  • Seite 27: Arabic

                    ‫دﻟﻴﻞ ﺗﺮﻛﻴﺐ اﳌﻜﻮﻧﺎت اﻟﺼﻠﺒﺔ‬ ‫ﺧﻄﻮات اﻟﱰﻛﻴﺐ‬ :‫اﻟﺨﻄﻮة رﻗﻢ 1. ﺗﺮﻛﻴﺐ وﺣﺪة اﳌﻌﺎﻟﺠﺔ اﳌﺮﻛﺰﻳﺔ وﻣﱪد وﺣﺪة اﳌﻌﺎﻟﺠﺔ اﳌﺮﻛﺰﻳﺔ‬ ‫1-2 ﻗﻢ ﺑﺎﻹدارة واﻟﻀﻐﻂ ﻷﺳﻔﻞ ﻋﲆ ﻣﺸﺒﻚ ﻣﺮوﺣﺔ وﺣﺪة اﳌﻌﺎﻟﺠﺔ‬ ‫اﳌﺮﻛﺰﻳﺔ ﰲ اﻟﻠﻮﺣﺔ اﻷم ﻋﱪ اﻟﻔﺘﺤﺎت ﻟﺘﺜﺒﻴﺖ ﻣﺮوﺣﺔ وﺣﺪة اﳌﻌﺎﻟﺠﺔ‬ ‫وﺣﺪة اﳌﻌﺎﻟﺠﺔ اﳌﺮﻛﺰﻳﺔ ﻣﻊ اﻟﻄﺮف اﳌﺴﻨﻦ ﳌﻘﺒﺲ وﺣﺪة اﳌﻌﺎﻟﺠﺔ‬ .‫اﳌﺮﻛﺰﻳﺔ...
                  • Seite 28 :‫اﻟﺨﻄﻮة رﻗﻢ 5. ﻛﺒﻼت اﻟﺘﻮﺻﻴﻞ وﻣﻮﺻﻼت اﻟﻄﺎﻗﺔ‬ ‫ ﺑﺎﻟﺠﻬﺎز ﻣﻦ ﻃ ﺮ از‬SATA ‫ب. ﻗﻢ ﺑﺘﻮﺻﻴﻞ ﻣﻮﺻﻞ اﻟﻄﺎﻗﺔ ﻣﻦ ﻃ ﺮ از‬ ‫ اﻟﺨﺎص ﺑﻪ‬SATA ‫ ﺑﻜﺒﻞ‬SATA ‫أ. ﻗﻢ ﺑﺘﻮﺻﻴﻞ ﻣﺤﺮك اﻷﻗ ﺮ اص ﻣﻦ ﻃ ﺮ از‬ SATA ‫د. ﻗﻢ ﺑﺘﻮﺻﻴﻞ ﻛﺒﻞ اﻟﻄﺎﻗﺔ اﳌﺰود ﺑﻌﺪد 4 دﺑﻮس‬ 0‫ج.

                  Diese Anleitung auch für:

                  H110m-c33

                  Inhaltsverzeichnis