Advanced Chipset Features - Ecs Rx480-A Handbuch

34
The disk drive software monitors the internal performance of the motors, media, heads
and electronics of the drive. The host software monitors the overall reliability status of
the drive. If a device failure is predicted, the host software, through the Client WORKS
S.M.A.R.T applet, warns the user of the impending condition and advises appropriate
action to protect the data.
Full Screen LOGO Show (Enabled)
When enabled, this will show a full screen company logo on the boot up screen. Select
disabled when you want to show POST messages during boot up.
Small Logo (EPA) Show (Disabled)
Enables or disables the display of the EPA logo during boot.
BIOS Rom TBL protect (Disabled)
This item enables or disables the BIOS Bootblock protect.

Advanced Chipset Features

These items define critical timing parameters of the motherboard. You should leave the
items on this page at their default values unless you are very familiar with the technical
specifications of your system hardware. If you change the values incorrectly, you may
introduce fatal errors or recurring instability into your system.
DRAM Configuration(Press Enter)
Scroll to this item and press <Enter> to view the following screen:
Downloaded from www.Manualslib.com
Phoenix-AwardBIOS CMOS Setup Utility
DRAM Configuration
LDT & PCI Bus Control
Video RAM Cacheable
System BIOS Cacheable
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
F5:Previous Values
Phoenix-AwardBIOS CMOS Setup Utility
Timing Mode
X
Memclock index value (MHz)
X
CAS# latency (Tcl)
X Min RAS# active time (Tras)
X RAS# to CAS# delay (Trcd)
X Row precharge Time (Trp)
X Row to Row delay(Trrd)
X
Row cycle time (Trc)
X
Row refresh cyc time(Trfc)
User Config mode
X 1T/2T Memory Timing
X Read Preamble value
X Async Latency value
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
F5:Previous Values
manuals search engine
Advanced Chipset Features
Item Help
[Press Enter]
[Press Enter]
Menu Level
[Enabled]
[Enabled]
DRAM timing and
control
F6:Fail-Safe Defaults F7:Optimized Defaults
DRAM Configuration
[Auto]
200Mhz
2.5
8T
4T
4T
2T
12T
24T
[Auto]
2T
6.5ns
5ns
F6:Fail-Safe Defaults F7:Optimized Defaults
Using BIOS
Item Help
Menu Level