Herunterladen Diese Seite drucken
Bodet Profil 730 Schnellstartanleitung
Vorschau ausblenden Andere Handbücher für Profil 730:
Quick start guide - Guide de démarrage rapide - Schnellstartanleitung - Guía de inicio rápido
INFORMATIONS RELATIVES À LA SÉCURITÉ
Nous vous recommandons de lire attentivement ce manuel avant l'installation du produit.
Tout usage non conforme à la présente notice peut causer des dommages irréversibles, et entraîner l'annulation de la garantie.
La responsabilité de la société BODET ne pourra donc pas être engagée.
Identification des pictogrammes :
Symbole
Description
IEC60417 - 1641
Manuel d'utilisation
INSTALLATION DU PRODUIT
L'installation et l'entretien de ce matériel doivent être réalisés par une personne qualifiée.
Installation électrique :
L'installation électrique de ce matériel doit être conforme aux règles édictées
dans les normes électriques en vigueur dans le pays d'utilisation du produit.
Les conducteurs d'un même circuit doivent être attachés entre eux près du bornier
pour éviter une réduction de l'isolation dans le cas où une des bornes viendrait à se desserrer.
Ouverture du produit :
Ce produit ne comporte aucun composant réparable par l'utilisateur.
Contactez le service client BODET si le produit doit être dépanné.
Ne jamais ouvrir le produit quand celui-ci est connecté
à une source d'alimentation. Couper l'alimentation en amont
(coupe-circuit, disjoncteur...) avant toute intervention sur le produit.
SAFETY INFORMATION
We recommend that you read this manual carefully before installing the product.
Failure to observe these instructions may cause irreversible damage and invalidate the warranty.
BODET shall not be responsible for any damage arising due to non-observance of these instructions.
Identification of pictograms :
Symbol
Description
IEC60417 - 1641
Operating instructions
INSTALLING THE PRODUCT
This equipment must be fitted and maintained by a qualified person.
Electrical installation :
The electrical installation of this equipment must comply with the rules laid down
in the electrical standards in force in the country where the product is used.
Conductors on the same circuit must be attached to each other close to the terminal
block to avoid reduced isolation should one of the terminals come loose.
Opening the product :
There are no user-serviceable components in this product.
Contact BODET customer service if the product needs to be repaired.
Never open the product while it is connected to a power source.
Before working on the product, switch off the power beforehand
(circuit breaker, etc.).
Non-contractual document © 2026, Bodet Time & Sport. All rights reserved.
Technical documentation available on www.bodet-time.com
Profil 730-730W-740
IEC60417 - 0434b
Attention
IEC60417 - 0434b
Caution
1
FR
IEC60417 - 6042
Danger, risque de choc électrique
10 mm
EN
IEC60417 - 6042
Caution, risk of electric shock
10 mm
>> www.bodet-time.com <<
loading

Inhaltszusammenfassung für Bodet Profil 730

  • Seite 1 We recommend that you read this manual carefully before installing the product. Failure to observe these instructions may cause irreversible damage and invalidate the warranty. BODET shall not be responsible for any damage arising due to non-observance of these instructions. Identification of pictograms :...
  • Seite 2 Wir empfehlen Ihnen, diese Anleitung vor der Installation des Produkts aufmerksam zu lesen. Jede nicht mit dieser Bedienungsanleitung übereinstimmende Verwendung kann irreversible Schäden verursachen und führt zudem zum Erlöschen der Garantie. Das Unternehmen BODET kann in einem solchen Fall nicht haftbar gemacht werden. Bedeutung der Piktogramme :...
  • Seite 3 Befestigungshalter mit Arm (ref.: 981 001 o 981 002) - Instalación con soporte doble cara (ref. : 981 001 o 981 002) Ø 6 mm 129,8 88 (Profil 740) Ø 6 mm 80 (Profil 730/730W) Non-contractual document © 2026, Bodet Time & Sport. All rights reserved. Technical documentation available on www.bodet-time.com >> www.bodet-time.com <<...
  • Seite 4 Die Feder ist starr. Seien Sie vorsichtig, um die Gefahr eines Einklemmens zu vermeiden. El resorte es rígido. Tenga cuidado para evitar el riesgo de quedar atrapado. Document non contractuel. © 2026, Bodet Time & Sport. Tous droits réservés. Documentation technique disponible sur www.bodet-time.com...
  • Seite 5 9 - 24 V NTP / WIFI - Horloge double Face - Double sided clock - Doppelseitige Uhr - Reloj de doble cara Non-contractual document © 2026, Bodet Time & Sport. All rights reserved. Technical documentation available on www.bodet-time.com >> www.bodet-time.com <<...
  • Seite 6 Uhren vorzunehmen. Bei 2 Netzleitungen ist die Vorgehensweise ähnlich: Anschlüsse wie bei einseitigen Uhren. Reloj de doble cara Profil 740 con iluminación led / reloj de doble cara Profil 730 - 740 con dos relojes cada uno con una fuente de alimentación : dividir el cable de red (con un dominó) para luego hacer un cableado de reloj de tipo una cara en cada uno de los dos...
  • Seite 7 Câble Ethernet - min Cat5 Cable Ethernet - minCat5 Ethernet cable - Cat5 min Ethernet-Kabel - Cat5 min Cable Ethernet - minCat5 Non-contractual document © 2026, Bodet Time & Sport. All rights reserved. Technical documentation available on www.bodet-time.com >> www.bodet-time.com <<...
  • Seite 8 Ethernet cable - Cat5 min Ethernet-Kabel - Cat5 min Ethernet-Kabel - Cat5 min Cable Ethernet - minCat5 Cable Ethernet - minCat5 Document non contractuel. © 2026, Bodet Time & Sport. Tous droits réservés. Documentation technique disponible sur www.bodet-time.com >> www.bodet-time.com <<...
  • Seite 9 HORLOGES NTP - NTP CLOCKS - NTP UHREN - RELOJES NTP Télécharger le logiciel «Bodet Detect» pour la configuration de l’horloge. Obtenez le lien de téléchargement dans la notice complète du produit disponible sur : www.bodet-time.com Download the «Bodet Detect» software for setting up the clock.

Diese Anleitung auch für:

Profil 730wProfil 740