DeFelsko PosiTest PG Gebrauchsanweisung Seite 6

Adjusting and Replacing Cutting Tips
Replacing Cutting Tips
1. Rotate the cutting tip holder into position.
2. Loosen the hex screw at the base of the cutting tip using the
included 1/8" hex wrench.
3. Remove the cutting tip.
4. Install a new cutting tip such that the tallest part of the cutting
tip is closer to the selection dial. Ensure that the cutting tip is
seated fully into the cutting tip holder.
5. Retighten the hex screw until the cutting tip is firmly held in
place.
4