Weekly Cleaning - Rex-royal S400 Betriebsanleitung

WEEKLY CLEANING

Start cleaning program (see page 32)
Intensive cleaning of powder module
1. The machine must be switched-off. Then open the front door
with the key on the left side.
2. Close the powder injections and clean the powder tubes (1).
3. Turn the yellow ring of the mixer cup (2) anticlockwise.
4. Remove the mixer cup and the mixer cup ring (3).
5. Drag the gray mixer rotor (4) off the shaft.
6. Unlatch and open the black cover flap (5) and remove the
filter (6).
7. Clean all parts thoroughly and wait until they are dried.
8. Put the parts in reverse order, together again.
�
ATTENTION: The mixer rotor (4) must fit exactly on the notch of
the motor shaft.
Intensive cleaning of outlet without milk module
1. The machine must be switched-off.
2. Remove the outlet cover (1).
3. Remove the coffee outlet (2) and the cover (3).
4. Pull carefully the powder outlet (4) from the mounting plate and
pull the piece of discharge of the hose.
5. Clean all parts thoroughly and wait until they are dried.
6. Clean the nozzles with the special brush.
7. Put the parts in reverse order, together again.
8. Check the tubes! There should be no kinked.
Intensive cleaning of mix outlet with fresh milk module
1. The machine must be switched-off.
2. Remove the outlet cover (1).
3. Open the catch handle (2).
4. Drag down the milk outlet (3).
5. Remove the spout tube and the connecting piece (4) from the
milk outlet.
6. Remove the piece of mixture (5) with the nozzle (6) and the
handle owner (7) from the milk outlet.
7. Remove the coffee outlet (8).
8. Pull carefully the powder outlet (9) from the mounting plate and
pull the piece of discharge of the hose.
9. Clean all parts thoroughly and wait until they are dried.
10. Clean the nozzles with the special brush.
11. Put the parts in reverse order, together again.
12. Check the tubes! There should be no kinked.
54
1
6
5
3
2
3
4
2
7
6
5
2
9
8
4
3
S400 - Operating Instructions S400 - Operating Instructions
4
1
1