Cleaning Powder Module - Rex-royal S400 Betriebsanleitung

Cleaning Powder module

1. The machine must be switched-off. Then open the front door with
the key on the left side.
2. Close the powder injections and clean the powder tubes (1).
3. Remove the yellow cup interlock; anticlockwise (2).
4. Remove the mixer cup and the mixer cup ring (3).
5. Clean all parts thoroughly and wait until they are dried.
6. Put the parts in reverse oder, together again.
Cleaning mix outlet (for fresh milk modules only)
1. The machine must be switched-off.
2. Remove the outlet cover (1).
3. Open the catch handle (2).
4. Drag down the milk outlet (3)
5. Remove the spout tube and the connecting piece (4) from the
milk outlet.
6. Clean all parts thoroughly.
7. Clean the nozzles with the special brush.
8. Put the parts in reverse order together again.
9. Check the tubes! There should be no kinked.
Operating Instructions - S400 Operating Instructions - S400
1
2
4
2
3
3
1
53 53