Adjusting The Bowl Tools - Kenwood KCC90 Bedienungsanleitung

adjusting the height of the tools
whisk, stainless steel K beater
For best performance the whisk and K beater should be
almost touching the bottom of the bowl
adjust the height using the spanner provided.
1 Unplug the appliance.
2 Raise the mixer head and insert the whisk or beater.
3 Lower the mixer head. If the clearance needs to be adjusted,
raise the mixer head and remove the tool.
4 Using the spanner provided loosen the nut
to allow adjustment of the shaft
to the bottom of the bowl, turn the shaft anti-clockwise. To
raise the tool away from the bottom of the bowl turn the shaft
clockwise.
5 Re-tighten the nut.
6 Fit the tool to the mixer and lower the mixer head. (Check its
position see points above).
7 Repeat the above steps as necessary until the tool is set
correctly. Once this is achieved tighten the nut securely.
high temperature creaming beater - this tool should just
touch the bottom of the bowl.
stir tool - this tool should just touch the bottom of the bowl.
1 Unplug the appliance.
2 Raise the mixer head and insert the stir tool.
3 Lower the mixer head. If the tool needs adjustment, raise the
mixer head and use the spanner to loosen the nut, then lower
the mixer head.
4 To lower the tool closer to the bottom of the bowl, turn the
adjustment wheel clockwise. To raise the tool away from the
bottom of the bowl, turn the adjustment wheel anti-clockwise.
5 Re-tighten the nut.
dough hook - this tool is set at factory and is not adjustable.
. If necessary
5
6
sufficiently
. To lower the tool closer
7
5
7
19
6