Serial Lost - Ditec Flashit Handbuch

3.9 SERIAL LOST

If, during the update process, the serial port is disconnected or, even worse, the card is
switched OFF by mistake, the update process stops immediately, leaving the firmware "hang-
ing" in the middle.
This condition is not problematic if the initial conditions are restored, i.e. the serial connected
correctly, and the board powered.
If you enter this error condition, the following message is displayed.
It is very important to restore the correct conditions otherwise the card is completely useless.
By re-establishing the serial connection and switching the board back ON, it will again be
possible to update the board.
Ditec brand is owned by ASSA ABLOY.All the rights concerning this material are the exclusive property of ASSA
ABLOY Entrance Systems AB. Although the contents of this publication have been drawn up with the greatest
care, ASSA ABLOY Entrance Systems AB cannot be held responsible in any way for any damage caused by mis-
takes or omissions. We reserve the right to make changes without prior notice. Copying, scanning or changing
in any way is expressly forbidden unless authorised in writing by ASSA ABLOY Entrance Systems AB.
The crossed-out wheeled bin symbol indicates that the product should be disposed of separately from
household waste. The product should be handed in for recycling in accordance with local environmental
regulations for waste disposal. By separating a marked item from household waste, you will help reduce
the volume of waste sent to incinerators or landfill and minimize any potential negative impact on human health
and the environment.
ASSA ABLOY Entrance Systems AB
Lodjursgatan 10
SE-261 44, Landskrona
Sweden
© ASSA ABLOY