Switch The Machine On And Off; Cleaning, Maintenance, Storage, Disposal; Cleaning; Maintenance - Zipper Zi-Rwm99O Benutzerhandbuch

15.7

Switch the machine on and off

16

CLEANING, MAINTENANCE, STORAGE, DISPOSAL

Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
 Always disconnect the machine from the power supply before cleaning,
maintenance or repair work and secure it against unintentional reconnection.
16.1

Cleaning

Regular cleaning guarantees the long service life of your machine and is a prerequisite for its safe
operation.
Incorrect cleaning products can attack the finish of the machine. Do not use any
solvents, nitro thinners or other cleaning products that could damage the machine's
finish.
Observe the specifications and instructions of the cleaning agent manufacturer.
After each use, remove dust and dirt particles from the machine.
•
• Clean the machine with a damp cloth and, if necessary, some commercial detergent or
blow it out with compressed air at low pressure.
Lubricate bare machine parts with an acid-free lubricating oil (e.g. WD40 rust inhibitor).
•
16.2

Maintenance

The machine is low-maintenance and only a few parts need to be serviced. Malfunctions or defects
that could affect your safety must be repaired immediately!
Before each operation, check the perfect condition of the safety devices.
•
• Regularly check the perfect and legible condition of the warning and safety labels of the
machine.
Use only original spare parts recommended by the manufacturer.
•
16.3

Storage

Store the cleaned machine in a dry, frost-proof and lockable place when not in use. Disconnect the
machine from the power supply. Make sure that unauthorised persons and especially children do
not have access to the machine.
Improper storage can damage and destroy important components. Only store packed
or already unpacked parts under the intended ambient conditions!
16.4

Disposal

Observe the national waste disposal regulations. Never dispose of the machine,
machine components or operating equipment in the residual waste. If necessary,
contact your local authorities for information regarding available disposal options.
If you purchase a new machine or equivalent equipment from your specialist
dealer, he is obliged in certain countries to dispose of your old machine properly.
17

TROUBLESHOOTING

Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
 Disconnect the machine from the power supply before starting work to
eliminate defects!
Many possible sources of error can be eliminated in advance if the machine is properly connected
to the power supply.
ZIPPER MASCHINEN GmbH
Switch on
Set ON-OFF switch to position ON (I).
•
Switch off
Set ON-OFF switch to position OFF (0).
•
W A R N I N G
W A R N I N G
www.Zipper-Maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
N O T E
N O T E
35
ZI-RWM99O